Requisite Audio Engineering L2M MKIII M/S VERSION Návod k obsluze stáhnout pdf (Strana 9)

FRONT PANEL CONTROLS (top row continued)

-20dB PAD

Applied only to the mic input before the microphone input transformer. If your source volume

is extremely loud and/or you are using a highly sensitive microphone, the -20dB pad may be

necessary to avoid distortion at the input.

OUTPUT LEVEL

MIC/DI INPUT MODE - This control should be adjusted for the desired output level (as indi-

cated on the VU meter) after all other controls have been set.

LINE INPUT MODE - This control should be set for the desired output level (as indicated on the

VU meter) after the LIMITER FEEDBACK, LIMITER RESPONSE and PEAK REDUCTION con-

trol have been adjusted. The PAL can provide up to 68dB of gain in the mic mode and up to

30dB of gain in the limiter mode and drive at +26dB before the clipping.

+48V PHANTOM POWER

For operation of microphones requiring +48VDC phantom power. Voltage only appears on MIC

INPUT XLR (pin-2 and pin-3).

VU METER (upper meter)

VU type meter allows for visual monitoring of the output level. Using VU ADJUST, 0dB can be

adjusted for any reference level desired. Before leaving our shop 0dB is set to +10dBu. This

seems to be a practical reference for driving digital recorders. Meter illumination is provided

and also serves as a system pilot light.

VU ADJUST (see FRONT PANEL CALIBRATION POINTS)

Provides continuously variable, user adjustment of the 0dB reference level. VU ADJUST is for

calibration of the VU METER (top meter) only. It does not affect GAIN REDUCTION readings.

THE PAL PLUS MKIII

R e q u i s i t e A u d i o E n g i n e e r i n g! L2M MkIII

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 18 19

Žádné komentáře

Requisite Audio Engineering L2M MKIII M/S VERSION Návod k obsluze Strana 9